Concept · 2026

Streets for people.
Parking goes vertical.

Up to 16 cars on the footprint of one parking space, below ground or above it.
Pavements cleared, façades untouched, fees paid into the city budget.

The problem

The city can’t get any wider.
Parking can go up or down.

Historic centres were laid out long before cars. Today cars stand on pavements and in courtyards and take up half the carriageway. A conventional underground car park is close to impossible here: dense blocks, listed buildings, old utility networks, years of construction and ramps that eat half the floor area.

25–30 m²per car in a conventional car park, including aisles and ramps
≈ 12 m²is enough for a robotic system: no ramps, no aisles, no people inside
up to ×10more cars on the same surface area, thanks to going vertical

Figures are indicative and need an engineering study for each site.

Land use compared

Same cars. A fraction of the city.

A surface car park gives every car 20–25 m² including the aisle. VERTA stores the same number of cars on the footprint of one to four parking spots, and the rest of the land goes back to the street. Both plans below are drawn to the same scale.

Basis: 2.5 × 5 m bays, 6 m aisle, double-sided row. VERTA area is the footprint at street level.

01 — Underground system

Shaft

All you see at street level is a glass pavilion the size of one parking spot. Below it is a robotic shaft: a lift lowers the car to a free level and a shuttle slides it into a bay. The driver never goes underground and the street skyline stays the same. The bottom level holds a robotic car wash in a sealed box, so the car is washed while its owner is at work. Below that is the plant level with the winch, control cabinets, batteries and water treatment.

Sheet 01/03 · Shaft Section A–A Drag to rotate Dimensions in metres
16cars on 8 levels
1parking spot at street level
≈ 20 mdepth including plant level
≈ 90 scar retrieval

How it works

  1. The driver pulls into the pavilion onto the shuttle comb and gets out. A camera reads the plate.
  2. A four-rope lift lowers the shuttle and car to a free level.
  3. The shuttle runs into the bay on rails and drops its comb: the car settles by its wheels onto the bay comb. The wheels never turn; the car is lifted, not pushed.
  4. The shuttle backs out under the car and the lift returns up. Retrieval runs in reverse, on request from the app or the kiosk.

Where it fits

Squares and small parks, wide pavements, courtyards. The shaft can extend under the carriageway, so only the entry point needs surface space.

Limitations

Geology and ground water, underground utilities, archaeology in historic areas. The highest excavation cost of the three concepts.

02 — Above-ground system

Rotor

A steel tower on the footprint of two parking spots. Platforms travel on a closed chain like a Ferris wheel and bring the requested car down. Installation takes weeks, not years, and the tower can be dismantled and moved.

Cladding
Sheet 02/03 · Rotor Axonometric Drag to rotate Dimensions in metres
12cars in one tower
2parking spots at street level
≈ 23 mheight including solar roof
≈ 2 mincar retrieval

How it works

  1. The car drives onto the lowest platform under its own power; the wheels sit in guide channels.
  2. A rooftop gear motor turns the sprockets through a chain drive. Two closed chains carry 12 platforms.
  3. Platforms hang on pivots and stay level under their own weight.
  4. The system turns the carousel the shorter way round to the requested car.

Where it fits

Gaps between buildings, blank gable walls, yards near markets, hospitals and stations. The cladding can be mesh, louvres, greenery or a media façade.

Limitations

The height needs heritage approval, so it doesn’t suit protected viewpoints. The drive needs acoustic insulation.

03 — Hybrid system

Module

Standard 2.75 × 6.0 m steel modules join into one block. The middle column is a lift, the others store cars on pallets. Pallets only roll sideways along the level rails and the lift only moves up and down; there are no ropes. The layout is assembled to fit the site: from two spots to a whole courtyard, from zero to two underground levels.

Width
Above ground
Below ground
Cladding
Sheet 03/03 · Module Configurator Drag to rotate Dimensions in metres
—cars in this layout
—parking spots at street level
—levels above / below ground
—density vs. a surface car park

How it works

  1. The lift goes up or down to the level where the requested car is.
  2. A drive roller under the cell pushes the pallet along the rails onto the lift platform. Level rails join module to module into one continuous line.
  3. The lift platform climbs toothed racks on the column posts: four gear motors with brakes and a safety gear, like a construction hoist.
  4. The lift brings the car to the gate and it drives out under its own power. The return runs in reverse.

Where it fits

Residential courtyards, institutional lots, plots next to new housing, temporary car parks. One standard part for every city simplifies production and certification.

Limitations

Lower density than the shaft or the rotor: the lift column stores no cars. The open structure needs façade cladding.

Comparison

One problem, three answers

01 Shaft02 Rotor03 Module
Street-level footprint1 spot2 spots2–4 spots
Capacity16–30 cars10–14 cars2–14 cars
Height / depth0 / up to 30 mup to 24 m / 0up to 11 m / up to 5 m
Impact on the skylineMinimalNoticeableModerate
Installation time*9–14 mo1–3 mo2–6 mo
Relative cost per space*●●●●○○●●○
Best forHistoric squaresGaps, yardsCourtyards, housing

* Indicative concept estimates. Actual figures depend on the site, geology and manufacturer.

Safety

Every bay under watch

There is a camera in every bay, on every rotor platform, in the shaft lift and at the entry. The dispatcher sees everything in real time and footage is archived. People never enter the machine zone: the system stores and returns the car.

Demo: plates are fictional, images are renders of the 3D model.

01

Camera in every bay

Recording 24/7, 30-day archive. Every car is visible from entry to retrieval.

02

Plate at the entry

The camera reads the plate, no tickets or cards. The car is only released to its owner: app, PIN or card.

03

People kept clear of machinery

Pavilion doors lock, and presence sensors and light curtains stop all motion the moment a person is in the zone.

04

Fire and gas

Smoke and CO detectors, automatic fire suppression, forced ventilation of underground levels.

05

Dispatcher 24/7

The operator’s monitoring centre, integrated with the city CCTV system.

06

Insurance

The car is insured for the whole stay. Every event is recorded and logged.

Protecting people

A person never enters the machine zone

The driver only ever sees the transfer zone behind the gate. Everything that moves works behind a closed gate, and only after the system has confirmed that nobody is inside.

01 · Entry
The gate opens only for a car whose plate the camera has recognised. While the gate is open, every drive is locked.
02 · Driver gets out
The driver switches off, gets out and takes their belongings. A display shows where to stop and what not to do yet.
03 · Confirmation
The driver leaves the zone and confirms in the app or at the kiosk that nobody is in or near the car. The gate closes.
04 · Zone check
Light curtains, presence radars, a thermal camera and weight sensors check the zone and the cabin. If any sensor detects a person or an animal, motion is blocked.
05 · Machinery moves
Only then does the system take the car. Doors to the machine zone are locked and alarmed; service staff enter only with a key and with the drives locked out.
06 · Emergency stop
Stop buttons are outside and inside the transfer zone, and the gate opens by hand from inside. Any trigger stops everything and calls the dispatcher.

Redundancy and autonomy

What if something goes wrong

Every critical component is duplicated, and no single failure locks a car inside.

Power cut
An on-board LFP battery runs the system for 4–6 hours, that is 20–30 retrievals. Solar panels on every system’s roof (5–9 kW) charge the battery by day and cover most of the consumption. There is a socket for a mobile generator. The last resort is a manual emergency drive.
Mechanism jammed
Two motors on every drive, each able to do the job alone. Brakes hold without power, and manual brake release lets the platform be lowered and the car returned. A service crew arrives within 2 hours.
Broken rope or chain
Doubled ropes and chains with a ×5 safety factor and safety gear like passenger lifts: the platform won’t fall even if one breaks.
No internet
The local controller runs on its own: retrieval by PIN or card at the pavilion kiosk, data syncs later.
Water in the shaft
Two drainage pumps with level sensors. If water rises, the system moves cars up from the lower levels in advance.
Sensor fault
Each platform’s position is tracked by two independent sensors: an encoder and limit switches. If they disagree, motion stops and service is called.

Engineering

Where the machinery lives, and how the wash works

Motors, control cabinets and batteries have their own room in every system and take no parking spaces.

Shaft · plant level
A dedicated 2.7 m level below the lowest bays: the lift winch with two motors, control cabinets and drives, LFP batteries, drainage pumps. A riser in the corner of the shaft carries water, sewer, exhaust and cables up to a service hatch at street level.
Rotor · rooftop plant room
The chain drive, control cabinet and batteries sit in a rooftop plant room under the solar panels, reached by a service stair inside the cladding.
Module · plant cabinet
The lift carries its own gear motors on the platform, while controls, batteries and comms share a 0.7 × 2 m plant cabinet at the end of the stack. It takes no parking space and is serviced from the pavement.
EV charging
In the module the car stands on its own pallet with a charging point and cable. The driver plugs the car in at the transfer zone and leaves. While the pallet moves it is unpowered. As soon as it settles in its cell, a power connector extends from the back, links it to the grid and charging starts; before any movement the connector retracts first. In the shaft the charging pillars stand at the far end of the ground spaces beside the pavilion. The rotor has no charging: its platforms are always moving.
Car wash · water
Fresh water comes from the mains through the riser. 80% of the wash water is filtered and reused, so a car needs only 30–40 L of fresh water.
Car wash · chemicals and drainage
Biodegradable concentrates sit in a dosing unit on the plant level; they are refilled monthly, with canisters lowered by the lift in service mode. Waste water passes a grit trap and an oil separator into a pumping station with two pumps that lifts it into the city sewer. Sludge is pumped out through the hatch twice a year.
Car wash · air and servicing
The box is sealed, with its own extract fan and dehumidifier, so moisture and chemicals stay out of the shaft. Brushes are replaced every 20–30k washes; chemical levels and pump status are monitored remotely.

City model

A standard design the city can replicate

Instead of approving every site separately, the city approves a catalogue of three systems and placement rules once. After that, each new location is a site adaptation, not a new project.

01

City

Provides the plot by lease, concession or public–private partnership. Approves the standard design and the zones where it may be placed.

02

Operator

Finances, builds and runs the system for 15–25 years. Responsible for safety, service and the app. Extra revenue comes from services while cars are parked: the robotic wash and EV charging.

03

Residents

Get a pass for a space near home, with priority for local residents. Visitors pay by the hour.

04

Outcome

The city frees pavements and lanes, gets a share of revenue and real demand data. The model works for other cities in Ukraine and the EU too.

Kirill Treitiak
Kirill TreitiakAuthor of the VERTA idea · co-founder of DOGMA

Project philosophy

A street is too valuable to be a place where cars just stand.

I have carried this idea for about ten years. Walking through historic city centres, I see the same thing every time: cars on pavements, in courtyards, double-parked along the kerb. The city can’t get any wider, and every year there are more cars.

Over these years the world has started moving the same way. Pilot robotic car parks are appearing in different cities, and demand grows every year. The technology already exists. What’s missing is a model a city can approve, finance and replicate.

VERTA shows what that model can look like. The name comes from the Latin verto, “I turn, I return”, and from the word “vertical”. We return space to the city by moving parking up or below ground.

Why these choices

  1. Minimum at street level. One or two parking spots stay above ground; everything else goes vertical.
  2. Heritage untouched. Cladding that matches the street, with no ramps and no excavation across half a block.
  3. Robots inside, not people. Less space, more safety, no hunting for a spot.
  4. Money to the city budget. A transparent model where the city is a partner, not just the one who signs off.
  5. One standard design. Approve it once and replicate it from city to city.

This concept was created by the DOGMA team. We are looking for partners among cities, system manufacturers and investors: for pilots in Ukraine and scaling worldwide, to keep improving the technology and make it more accessible and affordable.

Kirill TreitiakDOGMA · 2026verta.dogma.ooo

From idea to street

Let’s bring VERTA to life together.

VERTA is currently an idea and a concept. We invite investors, cities and system manufacturers who want to be first to bring robotic parking to the street.

asap@dogma.ooo